The Code of Federal Regulations of the United States of AmericaU.S. Government Printing Office, 1963 The Code of Federal Regulations is the codification of the general and permanent rules published in the Federal Register by the executive departments and agencies of the Federal Government. |
From inside the book
Էջ 188
... air- plane structure is required to support . ( e ) Yield factor of safety ... ( See definitions in this section and § 4a.61 . ) ( g ) Yield load . A limit load multiplied by the ... No general Page 188 § 4a.43 Title 14 - Aeronautics and Space.
... air- plane structure is required to support . ( e ) Yield factor of safety ... ( See definitions in this section and § 4a.61 . ) ( g ) Yield load . A limit load multiplied by the ... No general Page 188 § 4a.43 Title 14 - Aeronautics and Space.
Այլ խմբագրություններ - View all
The Code of Federal Regulations of the United States of America ..., Հատոր 1 Ամբողջությամբ դիտվող - 1939 |
The Code of Federal Regulations of the United States of America ..., Հատոր 3 Ամբողջությամբ դիտվող - 1939 |
Common terms and phrases
accordance Administrator aileron air speed air-speed aircraft Airplane Flight Manual airworthiness certificate altitude amended by Amdt angle approved brake calibrated carburetor cate center of gravity climb compartment compliance comply components configuration control surface control system critical engine demonstrated determined device dihedral angle equipment established FAA policies factor of safety failure fire flight conditions flight path flight tests fluid fuel system fuel tank ground gust indicator inspection installed instrument July 16 landing conditions landing gear level flight limit load load factor located maneuvers manufacturer material maximum continuous power means ments minimum normal operating limitations paragraph percent pilot pitch placard plane policies which apply position lights powerplant prescribed pressure procedure production certificate propeller retracted rotor rotorcraft specified stalling speed structure subchapter subparagraph Subpart Supp tail Technical Standard Order temperature tion trim type certificate type design vertical vibration wheel Wing flaps
Սիրված հատվածներ
Էջ 56 - Interstate air transportation," "overseas air transportation," and "foreign air transportation," respectively, mean the carriage by aircraft of persons or property as a common carrier for compensation or hire or the carriage of mail by aircraft...
Էջ 53 - Air transportation" means interstate, overseas, or foreign air transportation or the transportation of mail by aircraft.
Էջ 536 - When applied to sheet or structural members, fire-resistant material means a material which will withstand heat at least as well as aluminum alloy in dimensions appropriate for the purpose for which it is to be used. When applied to fluid-carrying lines, other flammable fluid system components, wiring, air ducts, fittings, and powerplant controls, this term refers to a line and fitting assembly, component, wiring or duct, or controls which will perform the intended functions under the heat and other...
Էջ 57 - ... and under the maximum conditions of rotor shaft rotational speed and gas temperature approved for the normal takeoff, and limited in continuous use to the period of time shown in the approved engine specification.
Էջ 358 - ... of this paragraph. These loads shall be multiplied by a factor of 1.15 unless the dynamic effects of failure under static load are otherwise taken into consideration. In the case of a pressure cabin, the normal operating pressures combined with the expected external aerodynamic pressures shall be applied simultaneously with the flight loading conditions specified in this paragraph. (1) An ultimate maneuver load factor of 2.0 at Vc.
Էջ 86 - A pull shall be required to obtain and maintain speeds below the specified trim speed and a push to obtain and maintain speeds above the specified trim speed. This shall be so at any speed which can be obtained without excessive control force, except that such speeds need not be greater than the appropriate maximum permissible speed or less than the minimum speed in steady unstalled flight. (b) The air speed shall return to within 10 percent of the original trim speed when the control force is slowly...
Էջ 278 - ... withstand heat at least as well as steel in dimensions appropriate for the purpose for which it is to be used. When applied to material and parts used to confine fires in designated fire zones, fireproof...
Էջ 55 - States; and (c) a place in the United States and any place outside thereof, whether such commerce moves wholly by aircraft or partly by aircraft and partly by other forms of transportation.
Էջ 232 - In any case not less than the minimum speed at which the controllability is adequate to proceed safely with the take-off, using normal piloting skill, when the critical engine Is suddenly made Inoperative.
Էջ 478 - ... speed, a specified power or a specified manifold pressure. Unless otherwise stated, the critical altitude is the maximum altitude at which it is possible to maintain, at the maximum continuous rotational speed, one of the following...