What people are saying - Write a review
We haven't found any reviews in the usual places.
Այլ խմբագրություններ - View all
The Code of Federal Regulations of the United States of America ..., Հատոր 1
Ամբողջությամբ դիտվող - 1939
The Code of Federal Regulations of the United States of America ..., Հատոր 8
Ամբողջությամբ դիտվող - 1939
acceptable accordance addition Administrator aileron aircraft airplane airworthiness altitude Amdt amended by Amdt appropriate approved assumed brake climb compartment complete compliance comply components conducted considered continuous crew critical demonstrated determined device direction distance effect emergency engine equal equipment established FAA policies failure feet fire flaps flight flight tests force fuel ground indicator inspection installed intensities landing gear least less limit lines load load factor located maneuvers Manual manufacturer marked material maximum means ments necessary normal NOTE obtained operation paragraph path percent performance permit pilot plane policies which apply position possible prescribed pressure procedure propeller protection range regulations result rotor rotorcraft safe safety shown side specified speed stalling standard strength structure Supp surface take-off tank temperature tests tion type certificate unit unless vertical weight wheel wing
Էջ 49 - States; and (c) a place in the United States and any place outside thereof, whether such commerce moves wholly by aircraft or partly by aircraft and partly by other forms of transportation.
Էջ 47 - Part 93, that airspace within a horizontal radius of 5 statute miles from the geographical center of any airport at which a control tower is operating, extending from the surface up to, but not including, an altitude of 3,000 feet above the elevation of the airport. Airship means an engine-driven lighter-than-air aircraft that can be steered. Air traffic means aircraft operating in the air or on an airport surface, exclusive of loading ramps and parking areas.
Էջ 255 - The speed 7,0 shall denote the calibrated stalling speed, or the minimum steady flight speed at which the airplane Is controllable. In knots, with: (1) Zero thrust at the stalling speed, or engines idling and throttles closed if It Is shown that the resultant thrust has no appreciable effect on the stalling speed; (2...
Էջ 479 - Flame-resistant. Flame-resistant material means material which will not support combustion to the point of propagating, beyond safe limits, a flame after the removal of the ignition source.
Էջ 47 - Landing area" means any locality, either of land or water, including airports and intermediate landing fields, which is used, or intended to be used, for the landing and take-off of aircraft, whether or not facilities are provided for the shelter, servicing, or repair of aircraft, or for receiving or discharging passengers or cargo. (23) "Mail" means United States mail and foreign-transit mail.
Էջ 52 - ... rotational speed and gas temperature approved for the normal takeoff, and limited in continuous use to the period of time shown in the approved engine specification.
Էջ 511 - Adequate provisions must be made to guard against inadvertent operation of the shutoff means and to make it possible for the crew to reopen the shutoff means after it has been closed.
Էջ 81 - This shall be so at any speed which can be obtained without excessive control force, except that such speeds need not be greater than the appropriate maximum permissible speed or less than the minimum speed in steady unstalled flight. (b) The air speed shall return to within 10 percent of the original trim speed when the control force is slowly released from any speed within the limits defined in paragraph (a) of this section.
Էջ 394 - A" for fires in ordinary combustible materials where the quenching and cooling effects of quantities of water, or solutions containing large percentages of water, are of first importance. (2) "B" for fires in flammable liquids, greases, etc., where a blanketing effect is essential. (3) "C" for fires in electrical equipment where the use of a non-conducting extinguishing agent is of first importance.